Photon Orange - Tacky Overgrip - Alien-Tek

Peel off the Protective Film: Your new grip has a protective film on one side. Make sure to remove it completely before you begin.

Identify the Adhesive Side: Peel off the paper backing to expose the sticky side of the grip. This is the side you'll apply to your paddle handle. You'll notice one end of the grip is slightly tapered – this is where you'll start.

Start at the Butt Cap: Hold your paddle with the handle pointing upwards.

Align the tapered end of the grip with the edge of the butt cap (the very bottom of your handle), placing it directly over your existing grip.

Start wrapping the grip around the handle, overlapping each layer slightly. You can control the thickness of your grip by adjusting the overlap.

Secure with Finishing Tape: Once you reach the top of the handle, trim any excess grip material. Use the finishing tape included in the package to secure the end of the grip in place.